99国精免费看,夜夜骑免费视频,日韩一区二区三区小视频,精品久久久久国产观看

歡迎進入濟南濟柴環能燃氣發電設備有限公司官網！

常見問題解答

燃氣發電機組充不進去電的原因

返回 2022.09.16 來源：http://www.51credits.cn 0
現在市場上賣燃氣發電機組的廠家越來越多，其實很多都是中間商，所以燃氣發電機組故障售后一般都很難去解決，這也讓很多客戶都是非常感慨的。比如燃氣發電機組充不進去電，下面就來講講這個問題。
Now there are more and more manufacturers selling gas generator sets in the market. In fact, many of them are middlemen, so it is generally difficult to solve the after-sales problems of gas generator sets, which also makes many customers very emotional. For example, the gas generator set cannot be charged with electricity, so let's talk about this problem.
小編認為燃氣發電機組充不了電有可能是保險絲或整流二極管損壞所造成的。當保險絲燒斷后，充電機電源指示燈不亮;整流二極管損壞后，充電機的電源指示燈亮，但無直流電輸出，其原因可能：
I think that the failure of gas generator set to charge may be caused by the damage of fuse or rectifier diode. When the fuse is burnt out, the charger power indicator does not light up; After the rectifier diode is damaged, the power indicator of the charger is on, but there is no DC output. The causes may be:
1、充電機變壓器被燒壞。
1. The charger transformer is burnt out.
2、充電機上的二極管被燒壞。
2. The diode on the charger is burnt out.
燃氣發電機組
3、充電機的充電電流表損壞。
3. The charging ammeter of the charger is damaged.
4、充電機的保險絲被燒壞。
4. The fuse of the charger is burnt out.
解決方法：斷開充電機與蓄電池的連接線，用萬用表直流電壓擋(50V)測試充電機兩個輸出接線柱間的電壓，注意紅表筆接充電機的正極，黑表筆接負極，發現無電壓輸出。
Solution: Disconnect the connecting wire between the charger and the battery, and use a multimeter DC voltage gear (50V) to test the voltage between the two output terminals of the charger. Note that the red probe is connected to the positive pole of the charger, and the black probe is connected to the negative pole. It is found that there is no voltage output.
拆下充電機外殼，對充電保險芯子進行檢查，發現60A的保險芯子燒壞。
Dismantle the charger housing and check the charging fuse core. It is found that the 60A fuse core is burnt out.
更換后，充電機恢復正常充電，故障即被排除。
After replacement, the charger will resume normal charging, and the fault will be eliminated.
以上就是關于燃氣發電機組充不了電的原因和解決方法，您對此有什么不了解的地方，可以隨時來我們網站http://www.51credits.cn進行咨詢。
The above is about the reasons and solutions for the failure of gas generator set to charge. If you have any questions about this, you can come to our website at any time http://www.51credits.cn Consult.

上一條：如何維護沼氣發電機并使其保持好狀態？

下一條：避免焦化發電機組的幾種錯誤啟動方式

新聞搜索
濟南濟柴環能燃氣發電設備有限公司

  • 服務熱線

    0531-62325028
    0531-69951266
首頁 - 新聞中心 > 常見問題解答

燃氣發電機組充不進去電的原因

現在市場上賣燃氣發電機組的廠家越來越多，其實很多都是中間商，所以燃氣發電機組故障售后一般都很難去解決，這也讓很多客戶都是非常感慨的。比如燃氣發電機組充不進去電，下面就來講講這個問題。
Now there are more and more manufacturers selling gas generator sets in the market. In fact, many of them are middlemen, so it is generally difficult to solve the after-sales problems of gas generator sets, which also makes many customers very emotional. For example, the gas generator set cannot be charged with electricity, so let's talk about this problem.
小編認為燃氣發電機組充不了電有可能是保險絲或整流二極管損壞所造成的。當保險絲燒斷后，充電機電源指示燈不亮;整流二極管損壞后，充電機的電源指示燈亮，但無直流電輸出，其原因可能：
I think that the failure of gas generator set to charge may be caused by the damage of fuse or rectifier diode. When the fuse is burnt out, the charger power indicator does not light up; After the rectifier diode is damaged, the power indicator of the charger is on, but there is no DC output. The causes may be:
1、充電機變壓器被燒壞。
1. The charger transformer is burnt out.
2、充電機上的二極管被燒壞。
2. The diode on the charger is burnt out.
燃氣發電機組
3、充電機的充電電流表損壞。
3. The charging ammeter of the charger is damaged.
4、充電機的保險絲被燒壞。
4. The fuse of the charger is burnt out.
解決方法：斷開充電機與蓄電池的連接線，用萬用表直流電壓擋(50V)測試充電機兩個輸出接線柱間的電壓，注意紅表筆接充電機的正極，黑表筆接負極，發現無電壓輸出。
Solution: Disconnect the connecting wire between the charger and the battery, and use a multimeter DC voltage gear (50V) to test the voltage between the two output terminals of the charger. Note that the red probe is connected to the positive pole of the charger, and the black probe is connected to the negative pole. It is found that there is no voltage output.
拆下充電機外殼，對充電保險芯子進行檢查，發現60A的保險芯子燒壞。
Dismantle the charger housing and check the charging fuse core. It is found that the 60A fuse core is burnt out.
更換后，充電機恢復正常充電，故障即被排除。
After replacement, the charger will resume normal charging, and the fault will be eliminated.
以上就是關于燃氣發電機組充不了電的原因和解決方法，您對此有什么不了解的地方，可以隨時來我們網站http://www.51credits.cn進行咨詢。
The above is about the reasons and solutions for the failure of gas generator set to charge. If you have any questions about this, you can come to our website at any time http://www.51credits.cn Consult.